Leather braided bracelets are a few of wrist accessories that being enjoyed an excellent good reputation for long time. Therefore, discover ways to braid them will add kicks with a personal outfit as well as create pretty gifts among girls. Now, see this braid bracelet pattern and will also be able to make an easy 6-strand bracelet within 30 minutes!
Supplies needed in the leather braided bracelet:
8mm Glass Pearl BeadsSkull Alloy Rhinestone Link
Crimp Bead
Cord Ends
Lobster Claw Clasp
.38mm Tiger Tail Wire
1mm Cowhide Leather Cord
Wire Cutter Pliers
Scissors
How you can braid the 6-strand bracelet?
1: Braid the 6-strand bracelet part
1st, cut three 80cm strands of leather cord2nd, fold them by 50 percent and tie the very center location simply by using a string
3rd, take R1 over R2, R3, L3 and L2, then bring the R1 under L2 and L3. Now, the R1 will be the new ldquoR3 rdquo
4th, take the L1 over L2, L3, (new) R3 and R2, then ring L under R2 and (new) R3
5th, repeat the 4th and 5th procedures with new R1 and L1 cord ends
6th, after the part reaches 2/3 of one 's bracelet, stop braiding and secure the positioning with tape
7th, finally, eliminate the excess leather cords.
2: Produce the focus beaded part
1st, attach the cord end with pliers
2nd, cut a short bit of tiger tail wire and thread it from the cord end on a single tip
3rd, slide one crimp bead, push upwards then squeezing with pliers
4th, string three pearl beads the other crimp bead on the wire, then thread through the whites with the skull bead. Finally, thread the wire back from the crimp bead. Pull tightly and squeeze the crimp bead
5th, open the following cord end and fasten the lobster claw clasp. Meanwhile, add one jumpring to another side with the skull bead.
Done!
Voil ! Making your individual leather braided bracelets is fun, easy and inexpensive. As a token of friendship, these handmade trinkets may worth more than the Swarovski crystals or any other precious gifts.
没有评论:
发表评论